The Gloyd-Mitchell Zone of the Rodessa Field

Many reservoirs are of the volumetric undersaturated type and their production, therefore, is controlled largely by the solution gas-drive mechanism. In many cases, the mechanism is altered to a greater or lesser extent by gravitational segregation of the gas and oil, by small water drives, and by pressure maintenance, all of which improve recovery. The… Continue reading The Gloyd-Mitchell Zone of the Rodessa Field

Kelly-Snyder Field, Canyon Reef Reservoir

The Canyon Reef reservoir of the Kelly-Snyder Field, Texas, was discovered in 1948. During the early years of production, there was much concern about the very rapid decline in reservoir pressure; however, reservoir engineers were able to show that this was to be expected of a volumetric undersaturated reservoir with an initial pressure of 3112… Continue reading Kelly-Snyder Field, Canyon Reef Reservoir

Material Balance in Undersaturated Reservoirs

The material balance equation for undersaturated reservoirs was developed: Neglecting the change in porosity of rocks with the change of internal fluid pressure, which is treated later, reservoirs with zero or negligible water influx are constant volume or volumetric reservoirs. If the reservoir oil is initially undersaturated, then initially it contains only connate water and… Continue reading Material Balance in Undersaturated Reservoirs

Calculating Oil in Place and Oil Recoveries Using Geological, Geophysical, and Fluid Property Data

One of the important functions of the reservoir engineer is the periodic calculation of the reservoir oil (and gas) in place and the recovery anticipated under the prevailing reservoir mechanism(s). In some companies, this work is done by a group that periodically renders an account of the company’s reserves together with the rates at which… Continue reading Calculating Oil in Place and Oil Recoveries Using Geological, Geophysical, and Fluid Property Data

Oil Reservoir Fluids

Oil reservoir fluids are mainly complex mixtures of the hydrocarbon compounds, which frequently contain impurities such as nitrogen, carbon dioxide, and hydrogen sulfide. The composition in mole percentages of several typical reservoir liquids is given in Table 6.1, together with the tank gravity of the crude oil, the gas-oil ratio of the reservoir mixture, and other… Continue reading Oil Reservoir Fluids

Introduction

At the beginning of this text, the various hydrocarbon reservoirs were subdivided into four types. This contains a discussion on reservoirs that have only liquid phases initially present. The will consider oil reservoirs that have an initial gas cap. These two reservoir types differ significantly from the gas reservoirs. The differences stem from the composition… Continue reading Introduction

Lean Gas Cycling and Water Drive

Because the liquid content of many condensate reservoirs is a valuable and important part of the accumulation and because through retrograde condensation a large fraction of this liquid may be left in the reservoir at abandonment, the practice of lean gas cycling has been adopted in many condensate reservoirs. In gas cycling, the condensate liquid… Continue reading Lean Gas Cycling and Water Drive

Comparison between the Predicted and Actual Production Histories of Volumetric Reservoirs

Allen and Roe have reported the performance of a retrograde condensate reservoir that produces from the Bacon Lime Zone of a field located in East Texas.13 The production history of this reservoir is shown in Figs. 5.6 and 5.7. The reservoir occurs in the lower Glen Rose Formation of Cretaceous age at a depth of 7600 ft (7200 ft… Continue reading Comparison between the Predicted and Actual Production Histories of Volumetric Reservoirs

Use of Material Balance

The laboratory test on the retrograde condensate fluid in Example 5.3 is itself a material balance study of the volumetric performance of the reservoir from which the sample was taken. The application of the basic data and the calculated data of Example 5.3 to a volumetric reservoir is straightforward. For example, suppose the reservoir had produced 12.05 MMM SCF of gross… Continue reading Use of Material Balance